Applications · Substations

Perimeter Intrusion Detection for Electrical Substations

An unpowered taut-wire barrier for the compound, with fence, gate and culvert sensors for the rest of the boundary.

Site layout

What Goes Where on a Substation

Most substations have a new or replaced barrier, a length of existing mesh fence, a vehicle gate and a cable trench or culvert. Each letter on the drawing matches a row in the table.

A typical substation compound. Letters A to E mark the boundaries listed in the table.
A typical substation compound. Letters A to E mark the boundaries listed in the table.
BoundaryProductWhat It Does There
A Compound barrier, new or replacedPerimTaut TW-100A physical barrier that alarms when a wire is pulled or cut. The detector needs no power and is unaffected by EMI/RFI.
B Existing mesh fence in sound conditionPerimOptic FO-750Sensing fiber fixed to the fence, up to 4 zones of 300 m per processor. The processor can sit up to 20 km away.
C Vehicle gatePerimWave MW-400A microwave link across the gate lane, 5–200 m.
D Cable trench or culvert under the fencePerimGrille FF-250A fiber-sensing grille that closes the opening. It can be used under water.
E Temporary opening during outage worksPerimWave MW-450MA portable, battery-powered microwave link, 5–200 m.

Why PerimTaut

Why a Taut-Wire Barrier Suits a Substation

A substation is surrounded by strong electrical fields, and many are unstaffed. The PerimTaut detector is mechanical: it draws 0 W at the post and is unaffected by EMI and RFI.

The pull threshold is adjusted on site, so contact from animals and plants is filtered out and crews are not sent out for nothing. The barrier rarely suffers damage while its protective materials remain intact. PerimTaut is priced competitively against systems of the same tier, with fast dispatch.

Next step

What to Send Us

Send what you have. We reply with a preliminary zone proposal and equipment supply quote.

  • Enough to start

    1. Site plan or sketch
    2. Fence or wall type, and the length of each section
    3. Photos of the boundary
    4. Gate and culvert positions
    5. Where indoor power is available